Page 2 - Bisagras Best
P. 2

GENERAL HINGE INFORMATION
     STANLEY ARCHITECTURAL HARDWARE
            Fasteners




                 1. Flat recessed head wood screw   2. Pan recessed head wood screw    3. Button head torx screw,
                                                                                              tamper resistant





                 4. Flat recessed head machine      5. Flat spanner head wood screw    6. Flat head torx screw, tamper
                   screw                                                               resistant





                 7. Flat recessed head machine      8. Sleeve nut and machine screw    9. Steel capnut and machine
                   screw      with grommet nut                                           screw for labeled doors





                10. Slotted head machine screw      11. Tek screw
            Half and Full Surface Hinge Fastenings

            Application of machine screw and cap nut and machine screw and grommet nut.
                                                                  •  Through-bolts and grommet nuts regularly furnished
                                                                    with half surface and full surface hinges
                                                                  •  Through-bolts and sleeve nuts available on special
                                                                    order
                                                                  •  Hinge back plates, BP-1, available for hinge sizes
                                                                     1
                                                                    4  /2” (114mm) and 5” (127mm). Holes accommodate
             Machine screw      Machine screw         BP-1          either sleeve nuts or grommet nuts
              and cap nut      and grommet nut   Hinge Back Plate  •  Special back plates are also available for swing clear
                                                  1
                                                [4  /2” (114mm) size   hinges
                                                     shown]
             How to Determine Hand of Hinge
            •  The hand of a hinge is determined from the outside of the door to which it is applied

            •  The outside of a cupboard, bookcase or closet door is the room side. For other doors, the outside is usually
              the side from which security is necessary
                                          Left Hand Reverse                                   Right Hand Reverse






                    Left Hand                                          Right Hand
                Left hand door takes   Left hand reverse door takes   Right hand door takes   Right hand reverse door takes
                  left hand hinges         right hand hinges         right hand hinges         left hand hinges
            •  It will be observed that this method of determining the hand of loose joint cabinet hinges is exactly the
              opposite from the furniture manufacturers’ standard rule
            •  To determine the hand of a loose joint hinge: open the hinge with its face toward you. If the knuckle of the
              right leaf is at the bottom, it is a right hand hinge. If the knuckle of the left leaf is at the bottom, it is a left
              hand hinge


                                           Left Hand                                  Right Hand
                                       Two-Knuckle Hinge                           Two-Knuckle Hinge




                                               GENERAL HINGE
    8
   1   2   3   4   5   6   7