Page 3 - Herrajes Patricios - Best

Proximity Card Reader Features
• HID and Motorola/Indala proximity cards supported • Eliminates reader interface board
• Usable in most environmental/exterior applications. • Incorporates 3 modules into a single electronics board inside IDH
Max escutcheon trim
1300 Option Features
• Eliminates need for small panel interface module • Connects directly to ACP via 2 wire RS485 connection

IDH MAX & IDH MAX 1300 Comparison Chart
®
®

IDH MAX ® IDH MAX 1300
®
• Prep door for IDH MAX ® • Prep door for IDH MAX ®
• Run single 4 conductor wire • Run single 4 conductor wire for
for IDH MAX ® IDH MAX 1300
®
®
• Install IDH MAX ® • Install IDH MAX 1300 which
• Install electrified hinge includes Intelligent System
• Mount PIM • Install electrified hinge
* Operates with most control panel ** Operates with Mercury control
hardware, Mercury control panels. panels only.

IDH MAX ® IDH MAX 1300
®
HM, KM, HW & KW – Options

AL – Besides complying with a wide variety of accessibility codes and ordinances, lever handles are available with a special abrasive feature.
Abrasive strip on the lever im me di ate ly identifies warnings on doors to hazardous areas for the blind.
BRK – When excessive force (approx. 300 inch lbs.) is applied to #4, #6 keyed knobs, they “breakaway” and spin freely, thus allowing entrance
only by key. Simple part replacement returns lock to func tion al usage.
C – The easy to use quick connect system enables efficient installation to the respective BEST Lock electrical options ordered.
IDH – The Integrated Door Hardware groups three components into one hardware package. 1. Door status switch (normally closed)
2. Request-to-Exit switch (normally open) 3. Electrically controlled locking mechanism.
KNL – Knurl feature is available only on #6 knobs. The knurling is machined into the outer edge of the knob. The knurled feature can be used for
blind, safe ty, or ac ces si bil i ty applications.
LL – Lead lined feature can be used to protect against X-rays. Since the majority of lead lined doors contain the lead in the surface of the door, the
knob lockset provide lead lining for the holes cut in the door when preparing the door for the trim.
LM – The Lost Motion feature allows the lever handle to turn freely when it is locked without retracting the latchbolt assembly.
This feature makes over-torque abuse more difficult to achieve.
SH – Security head provided for all exposed screws.
RQE – Cylindrical or Mortise locksets can be supplied with a request-to-exit switch. A normally open switch provides momentary switch closure
when the inside lever/knob is rotated.
TAC – Grooves are machined into knobs to improve grip or to be used as a warning in hazardous areas. This option can be used for blind, safety
or ac ces si bil i ty applications.
Thick door – Specify thickness if other than 1 3⁄4” .
TL – Tactile levers may be used in areas where improved grip is required or as a warning in hazardous or Safety First areas. Grooves are
machined into the back of the hand grasp portion of the lever to improve grip and/or provide a sensory warning. This option can be used for
blind, safety, or accessibility applications.
1300 – Integrated BAS1300/LNL1300 reader electronics board or (ISC) Intelligent System Controller is embedded behind the escutcheon secured
and out of site. Functions with Mercury on-line equipment only.
NOTE: 1300 option not available on any “EL” electrically locked functions.
W & M Series IDH MAX & Electromechanical Locks 3
®